DRAFTMASTER SX DRIVER

The message Calibrating will display. See your browser’s documentation for specific instructions. The plotting environment differs considerably from the calibration environment at the factory 18 to 30 degrees C, level floor. Remove the media from the plotter. Pen 8 will then be retrieved from the pen holder and a square will be drawn. When the calibration procedure is complete, the message Calibration complete will display. Raise the plotter’s carriage cover.

Uploader: Gok
Date Added: 26 February 2015
File Size: 8.40 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 87516
Price: Free* [*Free Regsitration Required]

Take care to accurately align the left pinch wheel with the left edge of the media. Make sure the pen is operational. Make sure the pen is in good operating condition and has a tip size of 0.

Calibrating makes the plotter’s drawing characteristics as accurate as possible. Rotate the page 90 degrees clockwise and reload the media in the plotter. Calibrating will display on the front panel and the calibration sequence will begin. This page requires Javascript. Europe, Middle East, Africa. Plotter parts have been changed pinch wheels, for example.

HP DraftMaster I, II, SX, RX and MX Plotters – Plotter Calibration | HP® Customer Support

When cutting and reloading the media, place the cut edge along the left side of the platen. Load a sheet of E or D size polyester film in the plotter. Raise the paper-loading lever.

  A DH16A3L DRIVER

Use a cloth dampened with water draftmastet this surface needs cleaning. The cut edge of the media should be along the left side of the plotter.

Modify your browser’s settings to allow Javascript to execute. Turn draftmaser plotter off and then on again to clear the display. If it does not have a paper cutter, use a sharp blade or another cutting device. See your browser’s documentation for specific instructions. Pen 8 will then be retrieved from the pen holder and a square will be drawn.

HP DraftMaster SX, RX, MX, SX Plus, RX Plus, MX Plus plotters – Internal Demo Plots

When reloading polyester film, place the writing surface face up; make sure the left pinch wheel is correctly aligned with the left edge of the plotting media. Remove the media from the plotter.

The plotter is calibrated at the factory using E-size AO polyester film and a black drafting pen. Handle the film by the edges so as not to get fingerprints on it.

When the calibration procedure is complete, the message Calibration complete will display. The pen holder will move across the platen.

  DELL E5500 LATITUDE BLUETOOTH DRIVER

If it has a rollfeed plotter, use the paper cutter to cut off the bottom of the page, dractmaster with the slot in the plotter’s platen. Pull the paper-loading lever towards you to raise the pinch wheels.

If the calibration fails, the message Calibration failed will display. Please try dfaftmaster shortly.

C Draftmaster SX Pen Plotter | eBay

The Virtual Agent is currently unavailable. This includes both the stripe and the white dots on either side.

The pen holder will move across the media several times, sensing the corners of the square just drawn. Raise the plotter’s carriage cover.

HP DraftMaster I, II, SX, RX and MX Plotters – Plotter Calibration

How does HP install software and gather data? Load a black drafting pen in stall 8 of the pen carousel. The plotting environment differs considerably draftmastrr the calibration environment at the factory 18 to 30 degrees C, level floor. Carefully align the line on the left pinchwheel with the left edge of the media.